2x8, 4x10 HD, 8x8, and 10x10 HD

Which plugin do I need?

Typically, the 4x10 plug-in (96kHz operation) for the 2x8/10x10 Hd, or the 10x10 plug-in (48kHz operation) for the 8x8/10x10 Hd. However, note that either plugin will run on either board.

Read Article

How do I get more than two digital output channels from DIGI-FP?

This platform only supports two digital output channels. For multichannel digital in/out, please check out the miniDSP nanoDIGI (SPDIF) and the miniDSP nanoAVR (HDMI).

Read Article

How do I get multi-channel digital input, like Dolby Digital or DTS?

The digital inputs are stereo only. It is not possible to use them with multichannel sources over a digital connection. The 8x8 and 10x10 Hd can be used with multichannel sources by using analog connections. Fo...

Read Article

Can I get the pinout/protocol for the VOL-FP header so I can interface to my own microcontroller?

Unfortunately, we can’t provide you with the protocol used for communication, as it’s beyond the scope of the product design and our support capabilities.

Read Article

Can I upgrade my 4x10 HD or 10x10 HD to Dirac Live?

No – these products don’t have enough processing power to run Dirac Live.

Read Article

Is there a plugin that runs the 10x10 HD at 96 kHz?

You can run the 2x8 plugin, which runs at 96 kHz, on the 4x10 HD. However, you will lose all but the first two input channels, and there will be fewer PEQs. You will need to copy over your configurations by han...

Read Article